![]() NOTE: In some cases you may not be able to directly access the board using SSH at this point. ![]() Install the driver on your Mac by clicking on the pkg file and following the instructions.Īfter installation you should at this point be able to access the onboard web server of the BeagleBone Black over the USB cable by going to in a browser. Grab the Network (HoRNDIS-rel4.pkg) driver file from the BeagleBone's mass storage device by clicking on the link in the START.htm file. Open up the BEAGLEBONE volume and click on the START.htm file, go to Step #2 in the file. Plug the board into your computer using the USB cable, wait while the board boots. The first gives you network-over-USB access to your BeagleBone, the second direct serial access. While Angstrom isn't a good platform to run the steward, we do want to install both Network and Serial drivers for Mac OS X before we go ahead and swap out our operating systems. The BeagleBone Black ships with a copy of Angstrom Linux on the internal eMMC. However if you are going to configure the board to use a WiFi adaptor you should use a supply with a 2A rating otherwise you'll get intermittent crashes due to brown outs. The power supply is not supplied with the board. NOTE: The board uses the same power supply as the previous BeagleBone. NOTE: You should use the mini USB port on the underside of the board to connect the BeagleBone to your computer, this is located on the underside of the board to the left of the Ethernet jack. Download the disk image, and install it as you would a normal version of the operating system. The steward will auto-start when the Beaglebone is booted, although especially on the first boot it may take a few moments to start as it has to generate an RSA key on startup. The disk image is the latest version of Debian Wheezy with the steward and its dependancies already installed. If you do not want to go through the manual installation steps below we supply a disk image for the Beaglebone Black. You should probably read through this file to familiarise yourself with the BeagleBone's capabilities. Open up the mass storage device and click on the START.htm file to open it in a browser. When startup is completed, a new mass storage device called BEAGLEBONE should appear on your desktop. The board should boot and you should see a solid blue light next to the 5V power jack. The mini port is located on the reverse side of the board near the Ethernet jack. The BeagleBone has two USB ports, a full sized USB-A port, and a mini-USB port. Starting with a new board the first step is to plug the board into your laptop using the mini-USB cable provided.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |